Questions & Answers

CM7000 + evo all

0 votes

Hello i m using standard installation with t harnesses, i cannot find a specific guide of evo-all + cm7000,

https://fortin.ca/download/87591/evo-all_ig_thr_bi_toy6-chr_2019_pts-hybrid_euro_a_87591.pdf

service number : 001A06753794

cm7000 has the connector nr.3 (Gray) with 6 pin, i connected the ground and the +12v in order to give power to the unit (i thought the voltage from the data port was enough, but it wasn't)

My question is on the pin nr. 5, guide says :

Pin 5 Green: Ignition 12V positive (+) output and input. This wire must be connected to the vehicles’
ignition for remote start and valet / remote programming. The proper wire will test 0V with the key in
the off position, 12 V (+) while the key is in the on position and 12V (+) during crank. Note: this is a
low current ignition output and will not support more than 1A (+)

 

Do i have to connect this wire to acc of my vehicle only for remote programming or it should be connected as permament? The evo all should give info of ACC ON to the cm7000 so this connection can be avoided right?

P.s I see the both cm 7000 and evo all are remote starter but i have to use the evo all as remote starter not the cm7000, so when i launch from the compustar remote the remote start routine how it works?

asked Sep 14, 2019 in Toyota by paolo fast (820 points)

1 Answer

0 votes
You should hook only power and ground to cm 7000 either on low current connector 3 or high current connector 1 thats it . than plug evo all to grey connector through datalink with cm 7000. also you should change gray port  option to fortin by default option is set to drone.

You dont have to hook up any other wire to cm7000 except them 2 wires datacable and your rf kit antenna.
answered Sep 14, 2019 by Palwinder Singh (570 points)
Thx for answer, today i installed the new system, everything works, but i think there is something wrong with the ignition. To pair the remote i forced 12v volt on the ignition input of connector 3 of the cm7000, paired succesful, lock unlock , remote start working. But with the engine running if i press the lock button on firstech remote the car starts the lock procedure : side mirror closing , lights off even if i'm running, radio power off and it s very dangerous if i m driving at night.

i dont know if i messed up with setting of cm7000 or the evo-all is not trasmitting ignition on, btw i was able to configure the ft-das without pushing 12volt on ignition on simpy turnig the igniiton from the pts button so the ignition on is sent to the cm7000 otherwise the ft-das can not enter in programming mode
connect the ignition wire per the guide and dont forget the diode.
...