2011 Ford E250, stuck on solid Red and Yellow Lights during EVO ONE programing procedure

Question

I finished installing the EVO One on my 2011 Ford E250. Made sure that all the wire were connected correctly based on Guide # 86051. I also installed a relay switch for the parking light the same way as shown in the wiring diagram. I used Flashlink to install the lattest 71.57 Bypass firmware and 1.26 Remote starter firmware. I tried many different troubleshooting steps such as disabled A11 according to the guide and changing the programable output to 2.2 to match the wiring diagram. I also tried older version of firmware to no avail.

No matter what I do, it always gets stuck on solid Red and Yellow Lights during step 4 of the the programing procedure when the ignition is turned on. The car I have is regular key without transponder chip. I tried both the 2 keys and DCRYPTOR programing procidure but both has the solid Red and Yellow issue as soon as the ignition is turned on. Please let me know what I am doing wrong and how I can resolve this issue.

Answer 1

Hello,

If the vehicle is not equipped with an immobilizer please follow the programming listed below:

Comments

Works! Thank You