EVO-ALL 2006 Ford Crown Victoria - Crank Once, No Start

Question

Hello, I have an EVO-ALL connected to a RS-X60-EDP+ Remote Start.

The remote start runs properly when a chipped key is in the PATS halo.

I attempted to program the EVO-ALL following programming sequence #2.

I have both keys and the bypass appears to be reading the input.

When I complete the programming sequence, by starting the remote start routine, the engine cranks, but will not run.

Subsequent attempts generate no crank at all unless I follow the programming steps again, however, it will only crank for the first remote start cycle.

The remote start only works if the chipped key is in the halo of the PATS (key need not be inserted).

The following wires are connected on the EVO-ALL
Blue GWR to remote start
Yellow Ignition to remote start
TX to PATS
RX to PATS
4 Pin bus to the remote start

Answer 1

What's the service number on the module?

Comments

001A06 762293

Hardware version 6

Firmware version 4.18

10/2017

Type  2

---

Does this mean the unit was used before it was sold to me?

 

EVO-ALL STATUS

Service No: 001A06762293

Preload date: 42-2017

Hardware version: 6

Firmware version: 71.46

Recommended version: 71.47

RS232 protocol: FORTIN

Vehicle: Ford Explorer 2010 - Standard-Key

 

 

---

Could be or it was just flashed for the wrong vehicle

---

I purchased it new from Lessco Electronics on Amazon. Do they come unflashed new?

---

Yes unflashed new