Issue after prgramming RFK942

Question

I installed the EVO-AUDT2 in my 2019 Audi Q7. Initially I did not have an rf kit so I was using my oem remote to remote start the car. And it worked perfectly. I then purchased the RFK942 and the RFA2A. Reflashed my EVO ALL with new setting to include the rf kit. After I program the RFK942 remotes and turn off the vehicle, all the lights (red, yellow, blue) on the EVO ALL flash for a few seconds and then turn off. Neither of the remotes work and my oem remote does not even work now. I have tried programming multiple times and all 3 lights on the EVO ALL just keep flashing for a few seconds after turning off the ignition and neither of the remotes still work.

Answer 1

Hello,

What is the S/N number on the back of the module?

When using the audt2 harness the rfa-2a is not needed, simply plug the antenna directly into the blue female connector on the audt2 harness.

"Reflashed my EVO ALL with new setting to include the rf kit"

- when you say reflash do you mean you re loaded the firmware into the unit? Or did you simply turn the options on and click save options?

Thank you.