Evo CHRT5 on 2015 Wrangler does not flash after turning key to on and off

Question

I started installing my remote starter and everything goes according to the guide, i get solid blue after pluggin in the EVO to the immobilizer, step after that the evo stays on solid blue after i put the key in turn to on and then off. i dont start the vehicle obviously but the light stays blue a solid bue.

I have the 4 pin black plug, 20 pin while, red plug and the 4pin white, in the instructions it says plug in the 2pin white connector which was not in the box. i ordered the right one for my Jeep, am i missing something? or do i need to do a different step.

Answer 1

You want to ensure you flashed the proper software version 4.18 or 74.07 and make sure the ignition yellow wire from the evo is hooked to the remote starter and t harness there shouldn't be a two pin connection required

Comments

So does that mean that the unit does not come flashed with the program when i bough it? I bought it from fortin

---

I.connected the yellow wires and the unit went through the programming cycle. Now when I try to start it I see the red alarm light flashing in the dash and the jeep doesn't start. Any help will be appreciated