Evo-One not programming door locks on 2013 Kia Soul (key start - uses a key)

Question

I've installed an EVO-One in a 2013 Kia Soul (has a normal Key to start vehicle).  The install was very simple, I did not that there is an error in the guide regarding the can bus. In this car, pin 6 (can high) is a blue wire, pin 14 (can low) is a red wire.  Initially I had only followed the color code and the unit would not learn the can bus at all.  I reversed the wires when I noticed the wires where reversed and the unit was able to learn the red (brake signal).  It is not able to learn the door unlock / lock from the can bus, and during the programming sequence, I never had the flashing blue sequence to learn the door locks.

I'm unsing a Fortin RF KIT 2W (RF642W).  I'm able to remote start the car, but once started, the OEM remote is unable to unlock the doors ( I need to use the key in the door cylindre).  The fortin RF kit is also unable to unlock / Lock  the doors.  I also can not stop the vehicle remotely, only by letting the time expire or pressing the break.

Appreciate any help.

Answer 1

We do not do doorlocks via can on your particular vehicle, you will need to connect those wires to the vehicle's analog doorlock wire, all information is available on Wirecolor.com.

 

What button combination are you using to shut down the vehicle when using the Fortin RF kit? You should be pressing the (-) button, then the start buttton.

Thank you,