MyCar and Fortin EVO-ONE with T-Harness setup on Subaru Outback 2017 Standard Key not working

Question

I'm trying to add MyCar to a Fortin EVO-ONE installation on a Subaru Outback 2017.

 

The Fortin EVO-ONE works fine - I can start the car using the OEM Standard KEY/Remote without any issues.

I followed the steps provided in the install guide to add the MyCar

 

Protocol is set up to Fortin2  using the FlashLink MAnager on EVO-One for RFKit

Setup as Fortin in the MyCar application Settings.

 

I did the following steps to learn the MyCar into Fortin EVO-One

1- Cycle the ignition to the ON position.

2 - The YELLOW LED on top of the EVO-ONE should come ON.

3 - Press and Hold the EVO-ONE push button for 5 seconds.

4 - The parking lights and the RED LED on the side of the EVO-ONE will turn ON.

5 - Release the push button.

6 - Press and Release the push button 5x times. Everytime the push button is pressed the parking lights and the RED Led on the side of the EVO-ONE will blink.

7 - Then Press and Release the Brake pedal.

8 - Seconds later the RED LED on the side of the EVO-ONE will blink once to confirm that the MyCar ID has been learned to the EVO-ONE.

9 - Cycle the vehicle’s ignition to the OFF position to Exit the EVO-ONE programming

 

All steps succesful. 

 

 

In the MyCar app I can see the voltage of the car and the GPS  location, however the START/STOP/LOCK/UNLOCK functions are not working from the MyCar application

 

 

Any ideas/help?

 

Thanks

VO

Answer 1

1) you need to plug theMyCar HRN-LLRS-01, please check installation details for mycar: https://fortin.ca/download/64631/omega-linkr-lt1-install-guide-64631.pdf

2) programming is as follows for evo one:

1: Turn ignition On

2: Turn ignition Off

3: Turn ignition On

4: Evo one Red LED "should" turn On

5: Press Brake Pedal 4 times

6:Red light will flash rapidly

7. Mycar is programmed

8: Turn ignition Off

Comments

Thanks for your help solving the problem.