2012 Honda civic valet switch not working.

Question

I installed Evo-One on honda civic 2012 with t-harness. Programming seems to have gone fine install seemed easy enough. Then I go to test the 3XLock to start and nothing happens, after checking settings and making sure harness wasn't damaged I decided to reset the unit and try again. When I turn on the car the valet switch does not enter unit into programming mode. I tried holding it for 10 seconds, I tried pushing it three times and nothing works. What could be wrong that would stop the Valet switch and remote start from working?

Answer 1

The valet switch is the one connected with a wire to the module, NOT the button on the side of the module. Make sure you are pressing the correct one.

When turning ignition on yellow light turn on ?

Comments

Yup, I can read too, anyone have some helpful advice?