2013 Wrangler unlimited, evo5/ALL?, 3x lock = no start?

Question

Instal/program went fine. all lights blink when suppose to. but nothing happens after 3x lock.

yellow wires were connected...

did notice one thing during programing, after the ignition was turned on, lights blinked, then i turned off, and i pressed the lock button it beeped once for when i locked it,  then it beeped again... is this suppose to happen?

do i need to purchase a flasher?

do i need to ground the blue wire?

service # 001A06 651007

Answer 1

Your module was flashed but the 3x lock feature is not enabled, you will need a flashlink updater 2 to enable the correct options C1 and D1.

Comments

Hey Mathieu, I have a 2014 Wrangler Unlimited. Followed all of the steps including enabeling the C1 D1 connected the 2 yellow wires. Pushed in button plugged in 4 pin got solid blue light, plugged in all the remaining connections, turned key to on blue lights blinked turned off hit lock blue light went off, tried the 3x lock, blue light blinks each of the 3 x  I hit the lock button , but it won't start . Is there another connection to make I am missing ?