EVO-ONE + EVO-START2 Combo - Evo-Start not sending command?

Question

EVO-ONE + EVO-START2 Combo

Standalone

2008 Mitsubishi Lancer

Car starts fine with factory remote. Evo-Start antennae blinks green a couple of times, then amber. 

It saying on my app, Sending, Car Locked. -- Sending, Car Unlocked. Etc. 

Nothing is happening. 

I have un paired and and re pogrammed several times. Nothing has seemed to work. Do I need the RFA2A?

I understand the topic has come up on here, and I have read through most of the answers, its just not happing for me. 

Answer 1

Rfa2a is for Evo-ALL only when you want to plug an RF kit with it.

 

Seems like your antenna is linked to your phone and receiving the command, this being said it looks like it's not paired with your Evo-One this why you have confirmation message but nothing happening in the car.

 

Try to do the validation, unhook the antenna connector in your windshield, turn Ignition ON, plug it back, will sequence 3 colour of led, when purple led blinking fast, turn Ignition OFF, doors should unlock if correctly programmed.

Comments

Ok, I did as you instructed.

 

The led did flash purple quickly, key off, doors did not unlock. 

 

I followed guide, 24841. Pg. 4 (Manual Trans). There was no lock or unlock or OBD wires to hook up. Only CanH and CanL. 

Could there be a setting off?

 

 

---

Try a master reset then, unplug the evostart ,wait 10sec, hold the button on it and plug it back in, led will blink his colours, release the button when led blink orange quickly, then it will flash blue once every second, press 1x the button, now it flash twice per second, hold it down until green led is solid.

 

after that do the remote learning sequence, ignition ON/OFF/ON , press the brake pedal 4times, evostart will blink blue led fast, hold it down until green led is solid

Answer 2

Sometimes if you delete the car permanently from your phone and add the activation code again solves the issue. give it a try.