Questions & Answers

2014 Toyota Tundra EVO-ONE Bypass Programming Step 4

0 votes
I am installing a EVO-ONE on my 2014 Toyota Tundra. I followed the "Key bypass programming procedure" steps 1-3 went as instructed. When I perform Step 4 both red and blue lights stay on solid and do not flash at all. I have done a master reset but am not able to get step 4 to complete.

 

Any suggestions?
asked Jan 18, 2015 in Toyota by Tim Wing (180 points)
edited Jan 18, 2015 by Tim Wing

1 Answer

+1 vote
 
Best answer
You need to press the programming on the module, not the one connected with a wire. The button is placed right next to the yellow loop.
answered Jan 18, 2015 by Tim Wing (85,210 points)
selected Jan 22, 2015 by Tim Wing
Thank you for the quick response Mathieu. Just to clarify, I was not using the valet button. I got to step 4 by using the programming button.
Your EVOONE is not flashed to the appropriate firmware, you absolutly need to update the module with a flashlink updater and a computer.

Mathieu, Got the flashlink and updated firmware. All is good now.

Thank you for the help.

...