Questions & Answers

Toyota Land Cruiser 2016

+1 vote
is it the same connection as 2008-2015? or there's changes
asked Nov 10, 2015 in Toyota by Ara Her (770 points)

1 Answer

+1 vote
Funny you asked. I got an email from someone else earlier asking if we had a solution since his ECM was different than the 2015.
answered Nov 10, 2015 by Robert T (302,110 points)
The ECM is different that's why I've asked but the system seems to be the same :) ,I will try to test one these days
commented Nov 11, 2015 by Ara Her (770 points)
It will most likely be pretty much the same install but wire locations will be different.
commented Nov 11, 2015 by Robert T (302,110 points)

Hello! We have tested this car in Russia. It is similar to the new Highlander PTS.

Connections: +12V, Ground, Ignition, Steering Lock (Red) and CAN-bus.

CAN-bus: BCM at left side of the Steering Column. Middle connector. Can-H (green 14pin), Can-L (white 13pin). It is important! Not OBD-II connector.

Firmware of EVO-ALL 79.30.

If you need to control the light and doorlock, look at the wiring diagram from Toyota Highlander 2015 PTS. It is the same.

P.S. Lexus LX570 2016 and Lexus LX450d 2016 will be the same.

 

commented Nov 12, 2015 by NilS (610 points)
Thanks Dmitry!
commented Nov 13, 2015 by Robert T (302,110 points)
Hi Dimitry, thanx for sharing. Did you try it on Standalone? I will check out this week and post my comments. Thanx all
commented Nov 14, 2015 by Ara Her (770 points)

Yes, we checked. Everything works great! There was a problem only for the diesel engine. Her fixed in firmware 0.54. This fix should be added to the official firmware 79.32.

commented Nov 16, 2015 by NilS (610 points)

Related questions

...