2021 Kia k5 trying to program the evo- all not programming at the final step.

Question

Hello, I'm getting all the way to where you press the button 6 times and the light is red.
 

I press the start stop button twice to turn on the button but the light on the evo doesn't change from blinking 6 times.
 

anything I'm doing wrong? I believe all the wires are connected properly and secure.

Answer 1

Hello,

What is the S/N number on the back of the module?

Best regards.

Comments

Still need to check the EMS comm wire but I can verify the A1 wire is good. When I go to press 6 times do I need to wait for it to finish blinking before I press each time?

it seems like now after I press it 6 times then press the stop start twice to turn on the ignition it just turns to a solid red and that's it.

---

press button 6x, connect all remaining connectors, turn ignition on. Again when you turn ignition on the module is checking the ignition (a1) wire and the ems com wire (A10).

Best regards.

---

when you press the button 6 times do you need to wait for the red light to stop blinking each time you do it?

---

No you can just press it 6 times and then just ensure you get the 5 flash and a pause repeating atferwards.

---

Can I send you a video of the sequence of me doing it? I have the yellow ignition wire and I have voltage there. I also have the EMS com wire connected. Which is cut. Yellow red going to the module and yellow green going to the harness side. I've verified it's the white wire on that module.